Ya that's that's a bit of a pi$$er. Still would have been a toss up to do a shop made tap though as it's a one time only use item....at least I don't have any plans to do a lot of 9/32 tapping.
But thanks for the link....that looks to be a good resource and the pricing is very good.
What's more of a PITA though is 3/4 of my last post seems to have disappeared.....wth happened there I wonder.
Sean
What are you talking about? The software shouldn't eliminate parts of posts.Originally Posted by SeanMP
I'd say I care- but I'd probably be lying...
Why thank ya fella's
I wasn't looking for kudo's on this one. I wanted to get some complete information published. When I went looking there was more fiction and bad information than fact. There is even a youtube video of sticking two screwdrivers down the hole and using a third as a prybar to turn the nut....In another your instructed to pound a piece of 1/8" pipe square then drill a hole in it??? After bending a 1/4" punch my feeling is that's just plain bad advice.
Sean
Posting Permissions
Reply With Quote
