Not getting a reply from my intrusion into the 2260 MRod thread I was still looking for an answer to my non-fabrication solution to the conversion.

Repeating old hat from GTA forum brought to this forum earlier this year. They suggested the PRod 2220-103 trigger group and the CH2009-110 Stroke Adjustment (that includes the hammer, striker and acetal Pin). That hammer assembly uses the 2100A011 hammer pin like the 2240 does.

I received a later recomendation to use the Maurder hammer. I can find no detail on the Prod hammer, but, the MRod hammer comes with a Hammer 1763-015, striker 1763A036, set screw, 1763-066 and an additional rear screw 1763-022 where the hammer pin would be.

Anyone use this Maurder hammer in a 22xx with success? I am tempted to use the CH2009 hammer assembly because it uses the same pin.....