Made some pellet traps.

[Bartman]

Hi Al. Nice job! When will these be available for purchase? And, special price for canadian airguns forum members?

Bart(man)

[Gippeto]

Anything is possible...what would a "fair" price be?

Material cost was ~ $45 each + wire and gas for the mig(maybe $5ea), burned up two zip disks...another $5ea, three cans of paiint...16.50. (call it $8 each) which brings the out of pocket to ~~ $63 each. Took ~2hrs or so to build each one.(cutting and jigging pieces eats up time)

Shipping will be a biggy too...figure they weigh in around 30lbs or so.

A cut list can be provided for free if you'd like. :)


Al

[Bartman]

Thanks Al. yes, I would like that. I realize it would be a HUGE shipping cost LOL. Take care, thanks, and nice job again.

Bartman

[Gippeto]

Cut list:

From 3/16" steel plate:

2pcs 12"x12" for the angle plates
2pcs 12"x10 5/8" for the sides (could alter this to 13" x 10 5/8" and close in the "flap" and the trap would sit "flat".

3/16 flat bar:

2pcs 3" x 6" to close in the sides of the rear tube half.

Misc:

1pc 12"x 6" diameter tubing. Cut in two equal pcs lengthwise. Wall thickness as close to 3/16" as can be found...the auger tube I used measures ~.160"

1pc 12" x 1/2"diameter hot rolled for the carry handle


Enjoy.

Al