Hi Al. Nice job! When will these be available for purchase? And, special price for canadian airguns forum members?
Bart(man)
Hi Al. Nice job! When will these be available for purchase? And, special price for canadian airguns forum members?
Bart(man)
Anything is possible...what would a "fair" price be?
Material cost was ~ $45 each + wire and gas for the mig(maybe $5ea), burned up two zip disks...another $5ea, three cans of paiint...16.50. (call it $8 each) which brings the out of pocket to ~~ $63 each. Took ~2hrs or so to build each one.(cutting and jigging pieces eats up time)
Shipping will be a biggy too...figure they weigh in around 30lbs or so.
A cut list can be provided for free if you'd like. :)
Al
Thanks Al. yes, I would like that. I realize it would be a HUGE shipping cost LOL. Take care, thanks, and nice job again.
Bartman
Cut list:
From 3/16" steel plate:
2pcs 12"x12" for the angle plates
2pcs 12"x10 5/8" for the sides (could alter this to 13" x 10 5/8" and close in the "flap" and the trap would sit "flat".
3/16 flat bar:
2pcs 3" x 6" to close in the sides of the rear tube half.
Misc:
1pc 12"x 6" diameter tubing. Cut in two equal pcs lengthwise. Wall thickness as close to 3/16" as can be found...the auger tube I used measures ~.160"
1pc 12" x 1/2"diameter hot rolled for the carry handle
Enjoy.
Al