Store Logo

+ Reply to Thread
Results 1 to 2 of 2

Thread: Hatsan AT44 10 QE .25

  1. #1
    Junior Member
    Join Date
    Wed Jan 24 2018

    Hatsan AT44 10 QE .25


    I purchased this gun just 2 months ago. I have about 200 shots through it so far. (It's old this time of year in Wisconsin). I saw where it is a good idea to clean the barrel when you get a new airgun so I was trying to remove the shroud to get to the barrel but the end cap is so tight I'm afraid I'm going to scratch up the end of the shroud trying to get it off. There is no way to budge it.

    Does anyone have any ideas?


  2. #2
    Administrator AirGunEric's Avatar
    Join Date
    Sat Dec 3 2011
    Somewhere Out There
    Why do you need to remove the shroud to clean the barrel? Use an aluminum cleaning rod and feed it through the shroud and into the barrel.
    I'd say I care- but I'd probably be lying...

+ Reply to Thread

Similar Threads

  1. Hatsan at44-10 5 screw mod failure continued.
    By Agedd in forum Co2 and Pre-Charged Pneumatic (PCP) guns.
    Replies: 4
    Last Post: Dec 17 2015, 01:41 PM
  2. Hatsan AT44-10 5 screw mod failure.
    By Agedd in forum Co2 and Pre-Charged Pneumatic (PCP) guns.
    Replies: 0
    Last Post: Dec 06 2015, 07:15 AM
  3. I am a big fan of Hatsan especiall AT44's
    By jaxworks in forum Airgun Picture Gallery
    Replies: 1
    Last Post: Jul 30 2015, 06:49 PM
  4. WTB: AR2078 or Hatsan AT44
    By hellhound in forum Wanted/Where to Find in Canada
    Replies: 1
    Last Post: Jan 13 2015, 12:44 AM
  5. Another story told by chrony Hatsan AT44 10/22
    By remtom1200 in forum Co2 and Pre-Charged Pneumatic (PCP) guns.
    Replies: 11
    Last Post: Jan 14 2013, 07:39 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts