Well there has been some grumblings about it being too quiet around here so I'll post up what I've been working for the last few days.

One of Eric's Lother Walther barrels machined for the 15mm AR/QBd configuration

I was waiting on bluing compound to complete the job. The bluing on this barrel is Slow Rust Blue. I think it turned out smashing

DSCF0170.jpg

Overall barrel showing the deep black of the rust blue process. This one shows warm tones in the right light which apparently is a sign of a fully developed rust blue treatment.

DSCF0172.jpg

View showing breach end. I tightened the tolerance over factory to minimize the wiggle these guns have in this area. Not by much though, a mere 0.003".

DSCF0171.jpg

View showing stepped target crown. It still needs the final pass with a brass crown tool

I can't wait for the opportunity to whistle a bunch of different pellets downrange...stay tuned