ScopesAndAmmo.com Store Logo

+ Reply to Thread
Results 1 to 3 of 3

Thread: Difficult Disco loading ??

  1. #1
    Member
    Join Date
    Sun Jan 8 2012
    Posts
    99

    Difficult Disco loading ??

    Hey folks i finally got my Disco back( actually recieved a replacement gun). While shooting a few pellets in the garage tonite i discovered that it is pretty tricky getting the pellet into the chamber and getting the bolt closed. I observed the same thing in my previous gun, as well as my buddies gun. Has anyone had this problem, and what did you do to correct it? Has anyone made a "loader" to get the pellet seated into the chamber?
    Bill

  2. #2
    Administrator AirGunEric's Avatar
    Join Date
    Sat Dec 3 2011
    Location
    Somewhere Out There
    Posts
    1,295
    Needs to be broken in a bit, should get easier over time to load the pellet/close the bolt.

    Only pellet loader I am aware of commercially available is the Crosman PL177- but only good for .177 pellets...
    I'd say I care- but I'd probably be lying...


  3. #3
    Member
    Join Date
    Sun Jan 8 2012
    Posts
    99
    Interesting little tool. I may have to pick up one and give it a try. Do u have them in stock Eric? Did you get my PM regarding the pump?
    Bill

+ Reply to Thread

Similar Threads

  1. WTB-Thumbhole Disco stock
    By FootedShaft in forum Wanted/Where to Find in Canada
    Replies: 24
    Last Post: Feb 14 2012, 08:51 PM
  2. 9mm and .308 cal Disco Build
    By rsterne in forum Co2 and Pre-Charged Pneumatic (PCP) guns.
    Replies: 29
    Last Post: Feb 04 2012, 04:16 PM
  3. Disco Double
    By rsterne in forum Co2 and Pre-Charged Pneumatic (PCP) guns.
    Replies: 5
    Last Post: Feb 03 2012, 09:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts