ScopesAndAmmo.com Store Logo

+ Reply to Thread
Results 1 to 5 of 5

Thread: New baby!

  1. #1
    Junior Member
    Join Date
    Fri Jun 17 2016
    Location
    Alberta
    Posts
    4

    New baby!

    My first air, a pal benjamin titan np in .22
    Was hoping to get some direction towards what to do with it before putting the first pellet in... any good instruction? Removing factory grease etc...

  2. #2
    Moderator rsterne's Avatar
    Join Date
    Wed Dec 7 2011
    Location
    Coalmont, BC
    Posts
    1,264
    Well for a start, the Titan is a Springer, not a Pumper, so you should post in the section below.... I'll move it for you....

    Bob
    Dominion Marksman Silver Shield - 5890 x 6000 in 1976, and downhill ever since!
    Airsonal:
    .177 Diana 34, 1750 CO2 Carbine, .177 Uber-Pumper, .22 Uber-Carbine, .25 Discovery, 22XX PCP 8-shot Carbine, 2260 PCP Rifle (50 FPE), Hayabusa PCP, .22 B-26, DAQ .308 Exile

  3. #3
    Junior Member
    Join Date
    Fri Jun 17 2016
    Location
    Alberta
    Posts
    4
    Lol, perfect.. thanks Bob - learning already.

  4. #4
    Administrator AirGunEric's Avatar
    Join Date
    Sat Dec 3 2011
    Location
    Somewhere Out There
    Posts
    1,265
    Learning the "artillery hold" would be a first good step.
    I'd say I care- but I'd probably be lying...


  5. #5
    Junior Member
    Join Date
    Fri Jun 17 2016
    Location
    Alberta
    Posts
    4
    Yup, that's a good one... My brother and I clear up the pasture of the gopher population every so often with his $50 princess auto special. They are jumpy to shoot for sure but once you get past that it's fun. I put 500 cpum's through it and the groups were terrible (still). 3-4" at 15 yards. Chrony averaged 720 fps... So I built a spring compressor, disassembled, and found two holes in the piston seal. Found out from some learned (and appreciated) people that the piston cylinder was slamming into the end of the compression chamber.

+ Reply to Thread

Similar Threads

  1. Replies: 2
    Last Post: Jan 06 2013, 02:58 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts