In an attempt to get my 760 back up to par, I added this to the transfer port...

trport.jpg

It is the plastic transfer port from the 760. It is a blurry picture, but the white blob at the port hole is the inner tube cut from a "pen switch." I used a 3/16 to slightly open the transfer hole of the plastic port and wrapped the tube with teflon tape. I stuffed it into the port halfway and the protruding tube was cleared of any excess teflon tape. What this now does is allow the tube to fit perfectly into the Valve Transfer Hole Seal and send the air straight into the plastic transfer port. The inner diameter of the tube is exactly the diamter of the valve hole so no restriction is taking place. I hope this helps to clean up any transfer leaks. But...

I still have a bolt probe leak and a I have a few nice scratches in the valves outer O-ring and pump cup. I'm also going to just use JB Weld (High Heat 800 psi) in order to seal the bleed hole.

Any suggestions, warnings? Thanks