ScopesAndAmmo.com Store Logo

+ Reply to Thread
Results 1 to 2 of 2

Thread: Screw Holders

  1. #1
    Moderator rsterne's Avatar
    Join Date
    Wed Dec 7 2011
    Location
    Coalmont, BC
    Posts
    1,265

    Screw Holders

    How many of you have had to shorten a screw and either damaged it, lost it, or even worse had it injure you?.... Yeah, pretty much everyone that works in a shop has burned their fingers, or had the grinder grab a screw and launch it into oblivion or crunch it to an unusable state.... Pliers?.... Nope, useless, been there, done that, got the T-shirt.... Well here is an idea I came up with to avoid that problem, and it even straightens the theads when you are finished munching on them....



    Just take a piece of scrap band iron or angle, and drill and tap some holes in it for the different screws you commonly use, particularly the smaller sizes, which are so difficult to hang onto.... I used a piece of 1" x 1/8" for the machine screws, and a piece of 3/16" thick 1"x1" angle for the bolts.... I marked the ends to indicate what the threads were with a Dremel.... You simply insert the screw in the hole, let it stick out the back, and put your finger against the head to prevent it from rotating and grind away.... The metal works like a heat sink to some degree, if it gets hot enough to burn your finger, you likely are getting the screw too hot and destroying the temper anyway, time to dunk it.... If it's a really short setcrew, stick an allen key in the socket to keep it from turning while you grind it....

    Finally, a way to shorten screws without losing or destroying them or getting hurt.... I'm sure somebody else thought of this long ago, but I've never seen it before....

    Bob
    Dominion Marksman Silver Shield - 5890 x 6000 in 1976, and downhill ever since!
    Airsonal:
    .177 Diana 34, 1750 CO2 Carbine, .177 Uber-Pumper, .22 Uber-Carbine, .25 Discovery, 22XX PCP 8-shot Carbine, 2260 PCP Rifle (50 FPE), Hayabusa PCP, .22 B-26, DAQ .308 Exile

  2. #2
    Administrator AirGunEric's Avatar
    Join Date
    Sat Dec 3 2011
    Location
    Somewhere Out There
    Posts
    1,266
    I used the same idea a few years back when Crosman was having problems getting an odd-sized grub screw in stock for one of their muzzle brakes (very short screw)- idea works well, but gets to be a real pain after about the 10th consecutive screw (in a batch job).
    I'd say I care- but I'd probably be lying...


+ Reply to Thread

Similar Threads

  1. How technology can really screw you over....
    By airgnr in forum Tavern Talk
    Replies: 2
    Last Post: Feb 13 2013, 07:36 PM
  2. Trigger adjustment screw access on B/S Trail NP All Weather
    By shotputter in forum Spring-Powered Guns
    Replies: 16
    Last Post: Sep 12 2012, 11:05 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts