Hello and looking for some help

[Pondhockey]

Hello Everyone,

I just purchased a Crosman Model 38T (looks to be dated April 75), it is a .22 calibre.

Bought a couple of Daisy Co2's today, as what I suspected it leaks, still shoots a pellet so thought that was encouraging. The Co2 grips is completely unusable.

So my questions today is does anyone have a pair of grips that they would like to sell and second where is the best place to buy a rebuild kit or is there someone in the Brantford area who rebuilds these at a reasonable rate.

Any suggestions would be fantastic.

thanks

[Doc Sharptail]

I think Eric at scopes and ammo may have a seal kit~ on a gun that old, probably most, if not all, the seals are going to need replacing.

Regards,

Doc Sharptail

[Fastair]

Take pictures as you go along if you take it apart. It makes it a lot easier to put back together.

[AirGunEric]

The seal kits are not a problem- but matching grips are- Crosman used different colour tones and patterns on the 38's over the years- so getting a matched set is potentially an issue...