Hi forum...
Went to shoot my 2078 this am, and it was bone empty... so it must have vented what little I put it away with a few days ago. So, I decided the time had come for a tear down and polish and to install those new seals Eric sent with the rifle. 3 questions:
1. What size hex key is used on the barrel setscrew? none of mine seem to fit it.
2. In the replacement seal kit there is one "white" colour O-ring where does it go?
3. The transfer port seals are less than square... how critical is the "squareness" of the cut... should I try to straighten them up?
Picture below:
QB.jpg