Hello Everybody,
I'm a new member and have some questions.
I have installed a Vortek PG2 kit with the red seal. It was fairly difficult to insert the piston with the red seal into the compression tube - I had to use some force.

Now when I fire the gun, it has a fairly sharp and loud crack, but the pellet only spits out from the barrel to a few meters (it actually once even remained In the barrel).
- What may be the problem?
- Is it the seal not installed correctly on the piston (or maybe it even became separated)?
- How do I know if the seal is on the right way when I install it on the piston? I put it in hot water for a few minutes, then pressed on the end of the piston. How far should it go on?
- Should I put some lubricant inside the compression tube when reinserting the piston? (Dieseling?...)
- If I need to buy a new seal, which one should I get? Is there a Canadian distributor?

Thank you for answering all these questions in advance!

Las