ScopesAndAmmo.com Store Logo

+ Reply to Thread
Results 1 to 2 of 2

Thread: Ruger Blackhawk problem after Vortek PG2 kit installation

  1. #1
    Junior Member
    Join Date
    Wed May 8 2013
    Location
    Peterborough, Ontario
    Posts
    2

    Ruger Blackhawk problem after Vortek PG2 kit installation

    Hello Everybody,
    I'm a new member and have some questions.
    I have installed a Vortek PG2 kit with the red seal. It was fairly difficult to insert the piston with the red seal into the compression tube - I had to use some force.

    Now when I fire the gun, it has a fairly sharp and loud crack, but the pellet only spits out from the barrel to a few meters (it actually once even remained In the barrel).
    - What may be the problem?
    - Is it the seal not installed correctly on the piston (or maybe it even became separated)?
    - How do I know if the seal is on the right way when I install it on the piston? I put it in hot water for a few minutes, then pressed on the end of the piston. How far should it go on?
    - Should I put some lubricant inside the compression tube when reinserting the piston? (Dieseling?...)
    - If I need to buy a new seal, which one should I get? Is there a Canadian distributor?

    Thank you for answering all these questions in advance!

    Las

  2. #2
    Junior Member
    Join Date
    Wed May 8 2013
    Location
    Peterborough, Ontario
    Posts
    2
    Never mind guys, I found the problem: I installed the piston seal the wrong way... Doooh :-( I don't know if this has happened to others, I feel stupid enough, regardless.
    The seal was tight up against the bottom of the compression tube - it was also a nice play to get that seal out from there )a 1-2Á dowel and a piece of a straightened coathanger wire with a 90 degree sharpened/flattened bend at the end did the trick.
    And now, onto the new seal.
    Any tips where to order from?
    Thanks in advance,

    Las

+ Reply to Thread

Similar Threads

  1. Replies: 1
    Last Post: Sep 18 2015, 08:03 PM
  2. Vortek kit blowout....
    By AirGunEric in forum Dealer Area
    Replies: 0
    Last Post: Nov 19 2012, 11:15 PM
  3. No lathe...No problem
    By jgoodz420 in forum Customization and Craftsmanship
    Replies: 2
    Last Post: Jun 24 2012, 07:30 PM
  4. Flow Through Bolt Problem...
    By sholo in forum General Airgun Questions
    Replies: 9
    Last Post: Mar 18 2012, 11:50 AM
  5. Forum picture posting problem- gone?
    By AirGunEric in forum Forum Announcements and Questions
    Replies: 13
    Last Post: Feb 18 2012, 02:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts