Printable View
Hello All,
lm looking for a scope arrestor block that will not damage the bluing on a Feinwerkbau 127, back in the day i had one, the only ones that worked was one that had a screw in the top of the block that screwed into one of the flutes on the top of the receiver. ls there a similar type setup that could be recommended that will not damage the bluing.
Cheers
"Screwed into one of the flutes"- this I find confusing. If you mean screw into the side of the mounting rail, this would also affect the bluing.
Do you have a hole near the rear of the rail where a scope ring with a stop pin could be installed?
Thanks for the reply.
lve attached a picture which might help show the flutes.
It appears you should be able to use scope rings with a stop pin, the pin being installed in one of the flutes.