Hi Al. Nice job! :applouse: When will these be available for purchase? And, special price for canadian airguns forum members? :glee:
Bart(man)
Printable View
Hi Al. Nice job! :applouse: When will these be available for purchase? And, special price for canadian airguns forum members? :glee:
Bart(man)
Anything is possible...what would a "fair" price be?
Material cost was ~ $45 each + wire and gas for the mig(maybe $5ea), burned up two zip disks...another $5ea, three cans of paiint...16.50. (call it $8 each) which brings the out of pocket to ~~ $63 each. Took ~2hrs or so to build each one.(cutting and jigging pieces eats up time)
Shipping will be a biggy too...figure they weigh in around 30lbs or so.
A cut list can be provided for free if you'd like. :)
Al
Thanks Al. yes, I would like that. :adoration: I realize it would be a HUGE shipping cost LOL. Take care, thanks, and nice job again. :applause:
Bartman
Cut list:
From 3/16" steel plate:
2pcs 12"x12" for the angle plates
2pcs 12"x10 5/8" for the sides (could alter this to 13" x 10 5/8" and close in the "flap" and the trap would sit "flat".
3/16 flat bar:
2pcs 3" x 6" to close in the sides of the rear tube half.
Misc:
1pc 12"x 6" diameter tubing. Cut in two equal pcs lengthwise. Wall thickness as close to 3/16" as can be found...the auger tube I used measures ~.160"
1pc 12" x 1/2"diameter hot rolled for the carry handle
Enjoy.
Al